Sodium Silicate/Aluminate Factory for High Dam (Aswan)

• Complete layout for the whole system (2D & 3D)
• Piping drawing for the backwash system
• Piping drawing of the drainage with all required dimensions according to specifications.
• Hydraulic study calculations of major and minor losses of the whole system.
• Valve sizing calculation analysis for all valves according to design inputs of head and discharge
• Pump sizing and selection analysis report based on the system discharge and head for all pumps
• Instrument list identifying all instrumentation provided with technical specifications.
• Piping and instrument diagrams (P&lDs) showing the complete system, including mechanical equipment, piping, fittings, connections, valves, ductwork, instrumentation, and controls.
• All tanks drawings with inlet and outlet connections, shut-off valves, control valves, drain valves, venting valves, instruments and gauages, neoprene connectors, vibration isolators.
• Tank calculation study providing for the design and analysis of wall and bottom plate thickness, service and maintenance considerations and other factors affecting tank design and safety, such as internal static pressure or weight, shell settlement, seismic and wind. (for all tanks)
• Provide approved/certified a closed-loop cooling system for autoclave-bearings identifying all components and accessories.
• Cooling calculations study for selecting an industrial packaged cooling system that shall be ASHRAE certified specifying technical data of chillers, heat exchangers, pumps, instrumentations, gauages, all accessories and connections according to specification and standards.
• Layout of water treatment system and provision of chemical cleaning with standard accessories and options such as feeding, dosing pumps. Complete with consumable materials and chemicals, shut-off valves, balancing, check, drainage, vent valves and chemical tanks, hoses, pumps and control panel with earthing rubber pad for sound isolation and supports against seismic, painting, insulation and cladding, testing, balancing, start-up,…….etc.
• Power and Control cable layout with all required dimensions.
• Electrical power distribution, single line and three line diagrams..
• Circuit and raceway schedule of supplied equipment including interconnecting wiring.
• Earthing System Layout and Calculations
• Instrument index identifying all instrumentation provided.
• Control panel/cabinet general arrangement drawings.
• Schematic diagrams, including the location of all devices when mounted in separate locations, and contact development for all control switches.
• Piping and instrument diagrams (P&lDs) showing the complete system, including mechanical equipment, piping, valves, ductwork, instrumentation, and controls.
• I/O Wiring and Connection Diagram – These drawings shall show all internal cabinet wiring and connections.
• Listing for data interface to DCS.
• System logic and functional control diagrams showing functional operation of the system.